Canfield Connector
Series 5000 SUB-MICRO Solenoid Valve Connector

SUB-MICRO SOLENOID VALVE CONNECTOR

Quote Request
Click to Enlarge

Canfield Connector’s Series 5000 Sub-Micro connector is made to connect solenoid valves using the DI N 43650 Form “C”, EN175301-803:2000 (8mm pin center) and the industry standard 9.4mm pin center. These standards permit industry interchangeability and have been embraced by the solenoid valve industry worldwide. Features include the ability for the user to wire the connector into existing installations or the connector can be prewired at the factory. Wire connections are made inside the connector housing. The wire inlet is either PG7 or 1/2" conduit. Maximum current rating is 6 amps with a maximum conductor size of 20 gauge with an outer jacket not to exceed .260 inches diameter. There are versions with indicator lights depicting the “on” state. The connectors are NEMA 4 and IP 65 environment rated.

  • The cable outlet can be assembled in 90° increments
  • Color: black, gray or translucent for lighted styles
  • Cable diameter: PG7 - .157 - .236 inch O.D.
    • 1/2" Conduit 8mm & 9.4mm - .250 inch max.

  • Cross section of the conductor wire max.: 20 AW G
  • Rated voltage max.: 250 VAC 50/60 Hz or VDC
  • Maximum approved current: 6 Amps

  • No. of contacts: 2+ ground,
    • 3+ ground (NOT available on lighted units)

  • Environmental protection: NEMA 4 and IP 65 dust tight and water resistant
  • Maximum rated temperatures for gaskets:
    • Nitrile gasket: -25° to +90°C
    • Silicone gasket: -40° to +125° C

Catalogs
Catalog Pages Catalog Pages
479.3 kB