Canfield Connector
Series R5000 Solenoid Valve Connectors

ISO RECTIFIED SOLENOID VALVE CONNECTORS

Click to Enlarge

Canfield Connector’s R5000 Series solenoid valve connectors incorporate full-wave bridge rectifiers inside the DIN 43650 Form "A" / ISO 4400, EN175301-803:2000 connectors. This standard permits industry interchange-ability and has been embraced by the solenoid valve industry worldwide. The R5000 converts alternating current to direct current reducing coil burnout due to valve sticking. Also, direct current eliminates AC "hum" inherent to alternating current. Features include the ability for the user to wire the connector into existing installations. Wire connections are made inside the connector housing and the wire inlet is either PG9 strain relief, 3/8" or 1/2" conduit. The R5000 has a maximum current rating of 1 Amp continuous with maximum wire gauge diameter of 14 AWG. An indicator light is offered for instant diagnostics and to aid setup and installation.

  • Voltage max.: 250 VAC 50/60 Hz
  • Voltage drop: 2.2 volt max.
  • Current max.: Continuous - 1 Amps
    •   Inrush - 15 Amps for 15 ms

  • Wire gauge max.: 14 AWG
  • Recommended cable diameter:
    •    PG9 - .236 to .315 inches O.D.
    •    PG11 - .315 to .394 inches O.D.
    •    3/8" Conduit - .410 inch max.
    •    1/2" Conduit - .410 inch max.

  • Gaskets temperature max.: Nitrile -25° to +90°C
    • Silicone -40° to +125°C

  • Environmental protection: NEMA 4 and IP 65 dust tight and water resistant 

Catalogs