Parker Fluid Connector Group
518C Series Non-Conductive Hose
518C Series Non-Conductive Hose
Key Features
- Twin or multi-line constructions available
- High density braid for maximum impulse life without loss of flexibility
Certifications
- Meets SAE J517 for less than 50 micro-amps leakage under 75,000 volts per ft.
- Meets or exceeds SAE 100R7 specifications and Electrical Standards except 518C-2 with respect to Maximum working pressure
- ANSI A92.2
Models Available
- 518C-2
- 518C-3*
- 518C-4*
- 518C-5
- 518C-6
- 518C-8
- 518C-10
- 518C-12
- 518C-16
Applications
- Medium pressure hydraulic service where both field attachable and permanent hydraulic circuit exposure and contact with high voltage may be encountered
Construction
- Tube: Copolyester
- Reinforcement: Fiber
- Cover: Proprietary Blend (PFX)
Operating Parameters
Temperature Range:
- -40°F to +212°F (-40°C to +100°C)
- (Limited to +135°F (+57°C) for synthetic hydraulic fluids and water-based fluids)
Min. Burst Pressure:
- 4:1 Design Factor is required if hose failure will result in movement of aerial device
- 3:1 Design Factor is acceptable if hose failure will not result in movement of aerial device
- Operating Parameters (cont.)
- SAE requires 4:1 Design Factor
Colors
- Orange
Fittings
- 51 Series – pg. E-5 55 Series – pg. E-12
- 57 Series – pg. E-37 58 Series – pg. E-12
- For Crimp Die Selection charts see pgs. G-30 : G-41
- Crimp information can be found online, for most Parker products, at www.parker.com/crimpsource
Notes
- Non-perforated cover
- Lay lines on this hose will have both ANSI and SAE maximum working pressure listed. ANSI A92.2-1990 “Vehicle Mounted Elevating and Rotating Aerial Devices”
- *3/16” and 1/4” working pressure reduced to 3,000 and 2,750 PSI respectively when using field attachable couplings
- 51 Series field attachable couplings are not intended for use on hose that has previously been in service
Catalogs
Catalog Pages
219 kB